Stanford study could lead to paradigm shift in organic solar cell research
November 20, 2013 Editor 0
Organic solar cells have long been touted as lightweight, low-cost alternatives to rigid solar panels made of silicon. Dramatic improvements in the efficiency of organic photovoltaics have been made in recent years, yet the fundamental question of how these devices convert sunlight into electricity is still hotly debated.
Now a Stanford University research team is weighing in on the controversy. Their findings, published in the Nov. 17 issue of the journal Nature Materials, indicate that the predominant working theory is incorrect, and could steer future efforts to design materials that boost the performance of organic cells.
“We know that organic photovoltaics are very good,” said study coauthor Michael McGehee, a professor of materials science and engineering at Stanford. “The question is, why are they so good? The answer is controversial.”
A typical organic solar cell consists of two semiconducting layers made of plastic polymers and other flexible materials. The cell generates electricity by absorbing particles of light, or photons.
When the cell absorbs light, a photon knocks out an electron in a polymer atom, leaving behind an empty space, which scientists refer to as a hole. The electron and the hole immediately form a bonded pair called an exciton. The exciton splits, allowing the electron to move independently to a hole created by another absorbed photon. This continuous movement of electrons from hole to hole produces an electric current.
In the study, the Stanford team addressed a long-standing debate over what causes the exciton to split.
“To generate a current, you have to separate the electron and the hole,” said senior author Alberto Salleo, an associate professor of materials science and engineering at Stanford. “That requires two different semiconducting materials. If the electron is attracted to material B more than material A, it drops into material B. In theory, the electron should remain bound to the hole even after it drops.
“The fundamental question that’s been around a long time is, how does this bound state split?”
Some like it hot
One explanation widely accepted by scientists is known as the “hot exciton effect.” The idea is that the electron carries extra energy when it drops from material A to material B. That added energy gives the excited (“hot”) electron enough velocity to escape from the hole.
But that hypothesis did not stand up to experimental tests, according to the Stanford team.
“In our study, we found that the hot exciton effect does not exist,” Salleo said. “We measured optical emissions from the semiconducting materials and found that extra energy is not required to split an exciton.”
So what actually causes electron-hole pairs to separate?
“We haven’t really answered that question yet,” Salleo said. “We have a few hints. We think that the disordered arrangement of the plastic polymers in the semiconductor might help the electron get away.”
In a recent study, Salleo discovered that disorder at the molecular level actually improves the performance of semiconducting polymers in solar cells. By focusing on the inherent disorder of plastic polymers, researchers could design new materials that draw electrons away from the solar cell interface where the two semiconducting layers meet, he said.
“In organic solar cells, the interface is always more disordered than the area further away,” Salleo explained. “That creates a natural gradient that sucks the electron from the disordered regions into the ordered regions. ”
Improving energy efficiency
The solar cells used in the experiment have an energy-conversion efficiency of about 9 percent. The Stanford team hopes to improve that performance by designing semiconductors that take advantage of the interplay between order and disorder.
“To make a better organic solar cell, people have been looking for materials that would give you a stronger hot exciton effect,” Salleo said. “They should instead try to figure out how the electron gets away without it being hot. This idea is pretty controversial. It’s a fundamental shift in the way people think about photocurrent generation.”
- Scientists develop heat-resistant materials that could vastly improve solar cell efficiency
- Innovative cell structure converts a record 44.7% of sunlight into electricity
- Stanford technology makes metal wires on solar cells nearly invisible to light
- UC’s SmartLight More Than a Bright Idea, It’s a Revolution in Interior Lighting Ready to Shine
- The Role of the Complementary Sector and its Relationship with Network Formation and Government Policies in Emerging Sectors: The Case of Solar Photovoltaics Between 2001 and 2009
- Modeling and simulations of a micro solar power system
Categories: Solar Energy
Tags: energy conversion, photovoltaics, physics, solar cells, Spintronics
Solar-powered battery woven into fabric overcomes hurdle for ‘wearable electronics’ HIV virus spread and evolution studied through computer modeling
Subscribe to our stories
- Entrepreneurial Alertness, Innovation Modes, And Business Models in Small- And Medium-Sized Enterprises December 30, 2021
- The Strategic Role of Design in Driving Digital Innovation June 10, 2021
- Correction to: Hybrid mosquitoes? Evidence from rural Tanzania on how local communities conceptualize and respond to modified mosquitoes as a tool for malaria control June 10, 2021
- BRIEF FOCUS: Optimal spacing for groundnuts in smallholder farming systems June 9, 2021
- COVID-19 pandemic: impacts on the achievements of Sustainable Development Goals in Africa June 9, 2021
Popular Post-All time
- A review on biomass-based... 1k views
- Can blockchain disrupt ge... 808 views
- Apply Now: $500,000 for Y... 806 views
- Test Your Value Propositi... 759 views
- Prize-winning projects pr... 727 views